Built In 12 Volt Refrigerators

12 Volt Refrigerators

2 year warranty on front opening models. Higher quality than most original equipment refrigerators. DC compressor true refrigeration with freezer, Not thermo electric coolers!  On / Off thermostat control.12v Draws only 6 amps, low voltage cut-out, Will Not Kill Your Batteries!

Built for heavy duty truck use, Built to last!

For full descriptions, specs and photos of the models listed, please visit our main website - TruckFridge.com

TF49_store_border TF49
$499.00

Fits most KW, Pete - 63" Sleeper, Freightliner Century, Columbia, Coronado, Cascadia, Mack, and 2009+ International Pro series Trucks. Power connection is made using T-shaped connector from the REAR of the cigarette lighter plug. (NEVER USE CIGARETTE PLUG AS PERMANENT CONNECTION!)

(Please measure your cabinet opening to insure you order the correct size fridge the first time. ~ Cabinet opening should measure approximately 15” wide)

NOTE: Freightliner Cascadia requires additional mounting plate not included with fridge. See options below.


TF65_store_border TF65
$549.00

Fits most Freightliner Classic, Pete 379 - 70" bunk and Pre 2009 International with added filler strip.

(Please measure your cabinet opening to insure you order the correct fridge the first time. ~ Cabinet opening should measure approximately 17 ¾" wide.)


TF130_store_border TF130 - 12 volt DC
$599.00

Fits most Volvo 770 (pre 2002) using both sets Volvo OEM floor mounting rails. (IMPORTANT - WILL NOT FIT VOLVO 780.) Some customers remove cabinets in International 9400/9900 series, Freightliner Classics for this larger than OEM fridge. In some cases, customers also have removed cabinets on Century/Columbia as well. Can be used to replace Norcold DE/DC0041 with side filler strips (customer supplied).

(Please measure your cabinet opening to insure you order the correct fridge the first time.~Cabinet opening should measure approximately 20 ¼" wide.)

* Optional installation trim flange add $50.00.


tf36_store_border.png TF36 Drawer DC 12-24 Volt
$599.00

Designed to fit under the bunk in the sleeper.

This sliding drawer arrangement allows a driver additional fridge capacity without losing valuable space in the cab.

This This is only a fridge, not freezer.

9 ¾”H x 17 ¼”W x 28 ½”D

DC 12-24 Volt

 

An optional trim flange is available to finish the front opening of cabinet when installing this model - TFFL36 $35.


blank_store_border FL130 Flange installation kit for TF130
$50.00

The FL130 Optional installation trim flange kit for TF130 and TF130 AC/DC gives a secure front mount and provides a finished front cabinet edge when installing the TF130 in a cabinet. - (115 Volt AC /12 Volt DC). Increases width 1 1/4" on each side and 1 1/2" on top.


Mounting_bracket_store_border Cascadia Mounting Kit (4 pcs.) - brackets and plates for TF49
$125.00

The Cascadia Mounting Kit (4 pcs) is required for installing a fridge in Freightliner Cascadia cabinet with trim bezel that did not have factory fridge. Black base plate and top bracket installs using existing holes in cabinet. No drilling required. Fridge plugs into existing factory wiring harness from the REAR of lower cigarette type plug. (NEVER USE A CIGARETTE PLUG AS A PERMANANENT CONNECTION.) Galvanized plates are attached to top and bottom of fridge, slide in and bolt to mounting plates. Final appearance is just like the OEM at a fraction of the price. Installation time is also faster and typically takes about 1/2 hour for an average person. This kit contains all the hardware needed. Requires basic hand wrench and socket. NOTE: If your cabinet has a door, this will need to be removed. Freightliner does sell a trim bezel for this cabinet when a fridge is installed. Freightliner Cascadia Fasica fridge cabinet trim frame without wood grain #A18-62503-002).


blank_store_border Cascadia 2 pc kit
$50.00
If your Cascadia had a factory fridge that you are replacing and the black steel mounting plates are still in the truck cabinet, these Top and Bottom galvanized plates are attached to the TF49 for direct slide in installation. (Remember this is ONLY for Cascadia that has factory fridge black bottom mounting plate and top bracket already in the cabinet.) If your Cascadia cabinet does not have factory black mounting plate inside the cabinet on the shelf, you will need to order the complete 4 pc kit ($125.)

To ensure you order the correct refrigerator for your truck, please measure your cabinet opening before placing your order. Failure to do so will result in the customer paying for shipping costs to retrun the unit back and shipping costs to send the correct unit.

 

 

Please note that models, prices, and availability is subject to change without obligation or notice.